The exhaust gas from the two chimneys of the machine shaft kiln enters the dust removal tower tangentially to form a cyclone under jet-induced acceleration. Due to the centrifugal force, most of the dust is thrown toward the wall of the device and captured by the internal and external water films to complete the first-stage division. The airflow continues to rotate. During the ascent process, the secondary dust removal is completed by spray washing.
1. Use double-cone tower to remove dust, so that the muddy water does not contact the wall of the cylinder, and prevent the blockage caused by sticky ash. 2. The sprinkler head is installed outside the dust area, so that the method and the sprinkler head are not in contact with each other, which solves the problem that the suction effect is affected because the sprinkler head is blocked and the water cannot be sprayed out.
This unit has a wide range of applications and can be used to purify non-fibrous, non-corrosive dusty gases with a turbidity not higher than 300 ° C. Suitable for metallurgy, coal, chemical industry, foundry, power generation, building materials and refractory materials. The dust removal in the viscous quick lime transportation system can also obtain good results, which is another outstanding advantage of the unit.
The wet dust collector is a comprehensive device integrating dust removal, desulfurization, self-discharge or mechanical ash discharge and automatic control of water supplement. It has the advantages of convenient operation and management, circulating use in the left and right dust collector of the solution, less water consumption, and economic operation.
CCJ multi-tubular impact dust collector When dust-containing gas enters the dust collector from the air inlet, large dust particles are blocked by the dust blocking plate, and smaller dust enters the CCJ multi-tubular impact dust collector combined box with the airflow. Inside. At this time, the dust-containing airflow is ejected from the nozzle through the ventilation duct at a relatively high speed, so the impact of the liquid surface impacts a lot of solution foam and water droplets.