DMF-Z-50S Right Angle Solenoid Pulse Valve The electromagnetic pulse valve (also known as the diaphragm valve) is the compressed air "switch" of the pulse bag dust removal and blowing system.Controlled by the output signal of the pulse spray controller, the filter bags are sprayed and cleaned row by row (room) to keep the resistance of the dust collector within the set range to ensure the processing capacity and dust collection efficiency of the dust collector. DMF-Z-50S electromagnetic pulse valve is a right-angle valve. The angle between the inlet and outlet is 90 °, which is suitable for the installation and connection of the air bag and the spray pipe of the dust collector.The air flow is smooth, and it can provide the dust cleaning gas pulse that meets the requirements. Working principle The diaphragm divides the electromagnetic pulse valve into two front and rear air chambers. When the compressed air is turned on, the compressed air enters the rear air chamber through the orifice. At this time, the pressure of the rear air chamber will bring the diaphragm assembly close to the valve output port. The solenoid pulse valve is in the "closed" state. The electric signal of the pulse spray controller moves the armature of the electromagnetic pulse valve back, the vent hole of the air chamber behind the valve opens, the back chamber quickly loses pressure, the diaphragm assembly moves backward, and compressed air is blown through the valve output port. "On" state. The electrical signal of the pulse blowing controller disappears, the armature of the electromagnetic pulse valve is reset, the vent hole of the rear air chamber is closed, and the pressure of the rear air chamber is raised to make the diaphragm assembly close to the output port of the valve.